Results 1 to 3 of 3

Thread: I can see ATR with CAS but receiver says "no card"

  1. #1

    I can see ATR with CAS but receiver says "no card"

    As the topic says when I am programming my card with CAS everything looks fine. ATR is there and result is "programmed successfully". However when I insert card into my receiver, a MVision ST5 USB, the receiver reports "card unknown" and "no atr". Any help would be appreciated. Many thanks.

    *p.s Card was working fine until today.

  2. #2

    Re: I can see ATR with CAS but receiver says "no card"

    Quote Originally Posted by Pappous65 View Post
    As the topic says when I am programming my card with CAS everything looks fine. ATR is there and result is "programmed successfully". However when I insert card into my receiver, a MVision ST5 USB, the receiver reports "card unknown" and "no atr". Any help would be appreciated. Many thanks.

    *p.s Card was working fine until today.
    you must put card opposite ....check

  3. #3

    Re: I can see ATR with CAS but receiver says "no card"

    OMG! I must stop vodka when doing stuff like that. Thanks

Similar Threads

  1. Replies: 0
    Last Post: 16-10-2009, 21:09:55
  2. Tutorial Please poste here all solutions card sharing ALI "B" et ALI "C"
    By radium in forum FTEmaximal Information and Tutorials
    Replies: 18
    Last Post: 03-05-2009, 13:43:56

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •