III-In this discussion, I shall gradually as explanations for beginners on how to use the Dreambox programs:
- for a first flash it is advisable to use instead of DreamUp Flashwizard it is a bit slow but it is more effective for the first time
* USE OF DreamUp:
- Disconect the dreambox sector and connect the cable RS232 of the dream to PC.
- Open DreamUp:
- Put into port: com1
Local IP (PC) the address of your pc (for the address of your pc type in cmd to run the command: ipconfig /all)
- Here the IP address of computer. is 192.168.1.10
IP Box is optional)
- Click on connect.
- Connect the dream to the sector, the horizontal scroll bar is filled (from left to right).
- Click right button marked "flash" fetching official images or CVS LZMA compatible, and click ok.
- It takes several minutes...
- Flash update finished, click ok.
- Unplug the dreambox sector, and reconnect it.
- It is now you need to configure your image in flash, satellite, network ...
* advice: when you set up your Dream save your image and save the DreamUp also with Flashwizard*