Results 1 to 2 of 2

Thread: programming TITANIUM CARD with CAS Interface 3Plus

  1. #1

    programming TITANIUM CARD with CAS Interface 3Plus

    Hello friends

    I have a problem programming my Titanium Card.
    Itís a Titanium card 3.25 or 3.4 (Iím not sure wich one) and Iím trying to program it using CAS Interface 3Plus.
    This is what I do: I open the CAS Interface Studio 8.7 and set Phoenix Mode 3.68. Then I open the Titanium Card Progger (Iíve tried several versions of that programmer), put in the card and it appears the following information: ATR: no ATR, unsupported Titanium OS found. And then I press the Erase button and on the screen appears ..sending TRAPCODE.. but nothing else happens. I keep waiting for about 3 hours and it still says ..sending TRAPCODE..
    Iíve even tried to switch off FIFO buffers, but itís still the same problem.
    Iíve red that I should open some programs like Microsoft Office to slow my PC down. Well I did so, but still nothing.

    About my PC: WindowsXP Professional, Service Pack 3
    Pentium 4, 2,6 GHz
    512 MB RAM

    PS do I have to put the card into the CAS interface with the chip UP or DOWN? (Iíve tried both, but am still not sure)

    Thank you.


  2. #2

    Re: programming TITANIUM CARD with CAS Interface 3Plus

    put inside with the chip down and then press slightly on the surface of the cas3plus, so the card-chip will get better contact to the reader. Try it several times. For me it works

Similar Threads

  1. Question Πρόβλημα με Cas Interface + usb
    By panoszax in forum Greek / Ελληνικά
    Replies: 3
    Last Post: 24-03-2009, 22:09:07
  2. CAS Interface 3
    By pic34 in forum French / FranÁais
    Replies: 5
    Last Post: 04-07-2007, 10:24:26
  3. Cas Interface 3 and ....
    By andreas_al in forum CAS Interface
    Replies: 19
    Last Post: 27-02-2006, 17:03:13
  4. cas interface 3
    By marcel in forum French / FranÁais
    Replies: 0
    Last Post: 23-12-2005, 21:14:00

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts