How To Install Omnikey Reader On Dreambox
A pack of drivers / dependency files has surfaced to install the Omnikey
to a Mipsel Dreambox. If you don't know a Mipsel dreambox is basically
the Enigma2 boxes, DM7025, 800 & 8000. This method is not applicable
for the older E1 boxes.
Basically the pack consists of 4 *.ipk installer files which will add the
required components to the Dreambox to run the Omnikey USB reader.
Your image will most likely have the ability to install these via your manual
install option in the addon panel, however to make sure everything is
correct I recommend you install via Telnet and follow this guide below.
FTP the 4 IPK files to your /tmp folder on the dreambox. Then start a
1. ipkg install /tmp/libusb_0.1.12-r0_mipsel.ipk
2. ipkg install /tmp/pcsc-lite_1.5.5-r0_mipsel.ipk
Installing libusb (0.1.12-r0) to root...
Installing pcsc-lite (1.5.5-r0) to root...
Adding system startup for /etc/init.d/pcscd ...
/etc/rc2.d/S20pcscd -> ../init.d/pcscd
/etc/rc3.d/S20pcscd -> ../init.d/pcscd
Starting PCSC Daemon: pcscd.
/etc/rc4.d/S20pcscd -> ../init.d/pcscd
/etc/rc5.d/S20pcscd -> ../init.d/pcscd
/etc/rc0.d/K20pcscd -> ../init.d/pcscd
/etc/rc1.d/K20pcscd -> ../init.d/pcscd
/etc/rc6.d/K20pcscd -> ../init.d/pcscd
3. ipkg install /tmp/libpcsclite1_1.5.5-r0_mipsel.ipk
4. ipkg install /tmp/ccid_1.3.11-r0_mipsel.ipk
Installing libpcsclite1 (1.5.5-r0) to root...
Installing ccid (1.3.11-r0) to root...
So, once all this is in place, connect the USB reader and set it
up in NewCS as normal. The reader type is
The node address will be simply
If you add a second reader it will be