Firmware version 2.02 for UFS 910si (BN 20,210,105) and UFS 910sw (BN 20210089)
With firmware version 2.02 the following improvements and new features are achieved:
Overall stability improvements
Improvements / solved problems:
Timeshift - problem in reaching the 4GB barrier
Timeshift - TS stops too early, recording is achieved as the end-stops TS, although
Play is not over
could shift - shift to terminate (before and EXIT REC), one receiver
Do not switch off by Standby button
BBC HD / ARTE HD DVB Sub
BBC 1 London TXT problem
Icons integrated VFD, except Dolby Digital
after PIP / HDMI resolution adjust unit does not operate, except for EXIT / MENU button
SI-update overnight started even if just a recording
Pipes to Scart output when "decoded PCM" -> to bring this
need to "SPDIF" and switched the receiver to be restarted
Note: Only works if no HDMI cable is plugged in parallel to Scart Cable
Common Interface -> CAM support
During playback of a recording may display the message: "Error pos same"
. Appear This is not a fault but an internal test mode,
in the final release is removed.
After the upgrade of the receiver is in "Menu -> Service Menu '
Factory setting perform
If the software already installed version 2.00, they shall recommend
we perform the update via USB stick.
During the update process must be connected to the external
USB hard drive be disconnected from the receiver