Results 1 to 4 of 4

Thread: How to use Groupkeyupdate ?

  1. #1
    Junior Member
    Join Date
    14-05-2005
    Posts
    20
    Uploads
    0

    Question How to use Groupkeyupdate ?

    There is a program call Groupkeyupdater for the dragon cards.

    Has anyonetried the pr0gram ?

    tks

  2. #2
    Member
    Join Date
    31-03-2011
    Location
    smartcardshk.com
    Posts
    58
    Uploads
    6

    Re: How to use Groupkeyupdater ?

    Quote Originally Posted by TVRO View Post
    There is a program call Groupkeyupdater for the dragon cards.

    Has anyonetried the pr0gram ?

    tks
    GROUPKEYUPDATE is for every irdeto based un_official cards it does not by itself you must have a valid HSN in your card
    you also need a pci card like skystar2 and you must log the data stream correct PID IDENT of provider - you log must be at least 200 mb

    once you have done the log you then use groupkey update and load the log - your card must be connected to a pheonix 3.68 mhz
    and you run the program - if you get message ex serial not found that means that log did not correspond with your HSN - try try agian
    or more or less log 200 mb stop and continue more logs maybe 1 week or 2 weeks each log 200 mb ...........

    thats the short info explained how it works - but its no good if your hsn is dead
    your card must contain a valid working HSN

  3. #3
    Junior Member
    Join Date
    14-05-2005
    Posts
    20
    Uploads
    0

    Re: How to use Groupkeyupdater ?

    Tks saladeang for your brief explanations.

    I have a couple of other questions

    1. to use groupkey updater, the card wills need a valid HSN. Then, when to use the groupkey updater ?

    2. If I know a valid HSN from a friend, is it possible to log the stream using that valid HSN and use the groupkey updater ?

    tks for your reply.

    TVRO

  4. #4
    Senior Member manous's Avatar
    Join Date
    23-01-2010
    Location
    Greece
    Posts
    222
    Uploads
    0

    Re: How to use Groupkeyupdater ?

    Forget the groupkey updater for activate your card with a valid HSN.
    1.Leave the card inside slot receiver and wait to take the key update.(est.1-12h)
    2.Send the line that corresponds to an active HSN (from a log file) using EMK - your card must be connected to a pheonix 3.68 mhz

    ps You can also create a log file using a dreambox with IRD Emm Extractor.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •