Manual Install Firmware by USB and Settings


Firmware Update by USB



1) Place the downloaded firmware in the root of a FAT32 formatted USB stick and put it in the usb slot receiver.

2) Press Menu on the remote control

3) Select Upgrade by USB

4) of the options that you can select All + Bootloader

5) Start

6) Remove the USB receiver


With this option you lose everything you have installed, channel lists, servers, etc. complete the firmware installed, this is good when you boot up the receiver.


The receiver will load the new firmware and when finished he just restarts and you just have to get the usb pen and ready to enjoy.



Installing only Settings


1) Insert the settings on a USB stick

2) Menu

3) Upgrade by Usb

4) userdb

5) Start



With this you just insert the new settings does not change the firmware.

The decoder will restart after the configuration update automatically with new updates.



Firmware Update only


1) Place the downloaded firmware in the root of a FAT32 formatted USB stick and put it in the usb slot receiver.

2) Press Menu on the remote control

3) Select Upgrade by USB

4) of the options you can choose maincode

5) Start

6) Remove the USB receiver



This only updates the firmware does not erase the channel list.

The decoder will restart after the configuration update automatically with new updates.



Thnx to Mega