Results 1 to 3 of 3

Thread: hashed tables

  1. #1
    Super Moderator turbopower's Avatar
    Join Date
    02-07-2011
    Location
    Somewhere between the Streams
    Posts
    3,512
    Uploads
    112

    hashed tables

    Вече има бета с тази функционалност, това според мен е най-хубавото което са правили напоследък.
    С други думи дори за голяма размяна cacheex ще може да се използва нормален хардуер, а няма да са нужни "супер компютри" както до сега.

    ***** CACHEEX MODE 2 ******
    Reader receive cws (and if cacheex_allow_ecm_request=1 send ecm requests too):


    [reader]
    label =
    protocol =
    device =
    user =
    password =
    group =
    keepalive = 1 //if camd35/cs378x it is useless, because is enabled by deafult. For cccam,use ccckeepalive=1.
    cacheex = 2
    cacheex_allow_request = //allow send ecm requests (default=1, as svn)
    #####cacheex incoming filter#####
    cacheex_maxhop = //max incoming cw hop (default=10, as svn)
    cacheex_drop_csp = //drop incooming cache from csp (deafult=0, as svn)
    caid = //incoming caid filter (default all)
    ident = //incoming ident filter (default all)
    services = //incoming services filter (default all). Take attention: if we have too much sids to check, incoming push could slowly!




    User send cws (and if cacheex_allow_ecm_request=1, answer to ecm requests too):


    [account]
    user =
    pwd =
    group =
    no_wait_time = //ignore wait_time at incoming ecm request (it works for not cacheex users too)
    cacheex = 2
    cacheex_allow_request = //allow incoming ecm requests (default=1, as svn)
    #####cacheex outgoing filter#####
    cacheex_maxhop = //max outgoing cw hop (default=10, as svn)
    cacheex_drop_csp = //not send cache recived from csp (deafult=0, as svn)
    caid = //outgoing caid filter (default all)
    ident = //outgoing ident filter (default all)
    services = //outgoing services filter (default all). Take attention: if we have too much sids to check, outgoing push could slowly!

    http://www.satsupreme.com/showthread...-code-release)

    Patch е прикрепен по долу.



    @blueven
    Here are my stats for cacheex only server with 6x mode3 peers & 3x mode1 users:

    9071 unpatched:
    Receive cache at 3 hops, & drop csp cache
    Send Cache at 3 hops
    cpu load averaged @ 80%

    9072 patched:
    Receive cache at 5 hops, & remove "drop csp cache" filter
    Send Cache at 3 hops
    cpu load is averaging @ 15%.

    So even when receiving an extra 2 hops & csp cache, cpu load has dropped by over 80%
    Ето и мнение на една от основните фигури стоящи зад oscam. Това обяснява всичко защо oscam не работи много добре като сървър и защо не е приоритед да се подобрява с тази насока.


    theparasol

    Sorry, I dont do cache-ex, I use oscam merely as a softcam on my enigma2 receiver to watch television with my subscription cards placed in internal readers.
    You must see the remarks in that light, no cache-ex, just oscam dvbapi to send ecm and emm and pull cw's from my local cards.
    In that case your patch loads the cpu a little bit more, but is very minor.
    People that do use cache-push will notice a very big decrease in cpu load and increase in cache hits.

    Many people may see oscam as a sharing tool but keep in mind:

    OPEN SOURCE COMMON ACCESS MODULE

    And that will still be the first and sole purpose for my point of view.
    I'll try to add code and fixes to enable oscam to watch television and make new cards and internal readers work.
    Attached Files Attached Files

  2. #2
    Super Moderator turbopower's Avatar
    Join Date
    02-07-2011
    Location
    Somewhere between the Streams
    Posts
    3,512
    Uploads
    112

    Re: hashed tables

    Ето build за RPi. Понеже нямам намерение да сменям cacheex с това устройство. Ако някой има възможност моля да тества.
    Attached Files Attached Files

  3. #3
    Senior Member
    Join Date
    05-02-2009
    Posts
    199
    Uploads
    1

    Re: hashed tables



    Устройсвото е mk908 с качено убунту и смесен оскам :)

Similar Threads

  1. New OSCAM Hashed Tables (beta code-release)
    By CapNCooK in forum OSCam Configuration and Support
    Replies: 28
    Last Post: 15-12-2013, 16:29:31
  2. Humax Files - PMCT Tables
    By lolazoca in forum Humax
    Replies: 2
    Last Post: 10-05-2009, 06:49:51
  3. Tables BX et FX
    By irene_julie in forum French / Français
    Replies: 11
    Last Post: 13-11-2007, 02:24:59
  4. reparation de tables
    By GOUTCHY77 in forum French / Français
    Replies: 55
    Last Post: 13-10-2007, 19:03:34
  5. Activation tables
    By NiKoMo in forum French / Français
    Replies: 8
    Last Post: 26-08-2007, 23:42:36

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •