Results 1 to 2 of 2

Thread: 2500E Firmware To Enable TV Mode Setting

  1. #1

    2500E Firmware To Enable TV Mode Setting

    Please help.

    I have a Coship 2500E with S6.4.1 firmware. However, this firmware does not allow me to change the "TV Mode" setting. It is permanently set to PAL but the manual says I should be able to toggle the setting from PAL to AUTO or NTSC.

    I want to change this setting to AUTO or NTSC as I have a dish set on Intelsat 701 C-Band to receive Nasa TV, which is an NTSC signal. With my Coship permanently set to PAL, the signal is not converted well and the picture glitches every few seconds.

    Can someone tell me if there is other firmware which I can install in my Coship to allow me to change the "TV Mode" setting from PAL to NTSC? Thank you in advance for helping.


  2. #2
    Junior Member
    Join Date
    25-02-2007
    Posts
    21
    Uploads
    0

    Re: 2500E Firmware To Enable TV Mode Setting


Similar Threads

  1. New Broadband Can Enable 'Saver’ Apps
    By Sat-Net in forum Daily Satellite TV News
    Replies: 0
    Last Post: 11-10-2009, 22:31:47
  2. Mode Asynchrone
    By 2cde in forum French / Français
    Replies: 0
    Last Post: 01-12-2007, 20:34:32
  3. mode d'emploi
    By sindebab in forum French / Français
    Replies: 0
    Last Post: 29-05-2007, 22:53:35
  4. Mode d'emploi
    By moroccino in forum French / Français
    Replies: 12
    Last Post: 03-01-2006, 00:35:12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •