Results 1 to 5 of 5

Thread: Stealth 2.53 problem

  1. #1
    New Member
    Join Date
    08-05-2005
    Posts
    7
    Uploads
    0

    Stealth 2.53 problem

    I tried to install in Diablo cam light the firmware stealth 2.53 but in 72% the installation stops and pops up the message “operation error”.
    Can anyone, please, make a backup of the firmware of his cam (2.53 or older) to install it with restore backup to cas interface 2.
    Thank you in advance!!!

  2. #2
    New Member
    Join Date
    10-09-2006
    Posts
    1
    Uploads
    0

    Re: Stealth 2.53 problem

    Try formating the cam first

    mb1

  3. #3
    New Member
    Join Date
    08-05-2005
    Posts
    7
    Uploads
    0

    Re: Stealth 2.53 problem

    I have made a format, but the problem remains. Can you sent me a backup of the firmware stealth 2.53 of your cam.

  4. #4

    Re: Stealth 2.53 problem

    When you format the Diablo it clears everything in the cam.
    Please remember Diablo is a very temperamental.
    Try downloading stealth 253 again (remove the one you could not use) and program the cam again if the problem still there try again and again.

    Try a different USB port and USB cable.

    Cas 2 is a little old but it should do the job, i was getting few problems using Cas 2 like having to program the cam few times in the end it did the job since i change to cas 3 plus only once i had to program the cam again in 12 months and it was the Dragon cam.

    It helps if you mention your set up.

  5. #5
    New Member
    Join Date
    08-05-2005
    Posts
    7
    Uploads
    0

    Re: Stealth 2.53 problem

    Problem o.k with cas interface 3 +

Similar Threads

  1. Tps with stealth 2.34
    By stonne in forum Diablo Cam
    Replies: 11
    Last Post: 06-02-2008, 10:11:01

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •