Hi,can anyone help me?,i'm trying to set up my moteck onto a 1m funke dish,using the motor booklet i set the elevation angle with the scale on the side of motor to 53 deg(lat for n/west Eng.then it says set declination angle which according to table is 7.6 and for this motor gives a dish angle of 22.4(30-dec.angle),the dish bracket which mounts dish to motor has a scale on a sticker allowing the bottom clamp to move but i don't know what to use as a marker ? i phoned sat superstore who i bought the dish off and they said my dish should be setup vertical as it's an offset dish?now i'm confused as moteck book says nothing about offset dishes!! any help would be greatly appreciated thanx.