Does anybody have some knowledge to explain this:
I have the latest firmware on my ST-5 (MV-S5-6.06.05-HS_scam-131). I scanned Hotbird, Astra and Eutel W2.
Now, If I am on a Hotbird channel and I select, say, an Eutel one, the motor turns the dish to Eutel.
However, If I then select a channel on Hotbird again the motor doesn't appear to move the dish back except if I choose one particular channel; then it moves is back to Hotbird.
If I go to motor setting and select Hotbird and then go back to the channel list, all Hotbird channels work again.
It is a similar scenario between Hotbird and Astra.
I use USALS and my old Technomate TM 1000 D used to spin the dish without any problem.
I am not entirely bad in logics but this definitely cancels it all together.