I can see ATR with CAS but receiver says "no card"

[Pappous65]

As the topic says when I am programming my card with CAS everything looks fine. ATR is there and result is "programmed successfully". However when I insert card into my receiver, a MVision ST5 USB, the receiver reports "card unknown" and "no atr". Any help would be appreciated. Many thanks.

*p.s Card was working fine until today.

[gamata]

As the topic says when I am programming my card with CAS everything looks fine. ATR is there and result is "programmed successfully". However when I insert card into my receiver, a MVision ST5 USB, the receiver reports "card unknown" and "no atr". Any help would be appreciated. Many thanks.

*p.s Card was working fine until today.

you must put card opposite ....check

[Pappous65]

OMG! I must stop vodka when doing stuff like that. Thanks