WINDOWS 7 64bit plus cas3 software

[stuarth]

Is there a version of the software written for windows 7 64 bit as the normal softwarfe just says for x86 only ??

[Wembley]

Is there a version of the software written for windows 7 64 bit as the normal softwarfe just says for x86 only ??

Hi dear

sorry the only version available at the moment is Cas Studio 8.6c it works fine for windows xp but I dont know about windows 7 64bit if you have any problem juste tell us good luck

[stuarth]

Duolabs have just sent me latest cas software 8.7 still does not work with win 7 64 bit vers , does anybody have a working version ????

[warhawk]

I have exactly the same problem with Windows 7 64-bit !

[johnlonghair]

Sorry to say, but I can't install cas3 or TwinbaseManager 2.11 on win 7 X64 too. Hope there will be a solution to this problem soon.

Grtz john

[whozebest]

Hi guys,
I had the same problem, and I solved it using the XP virtual PC.
Need to install it then in the virtual PC install cas studio. Normally the virtual console use the drivers of windows 7, as they are not installed in W7 it says unknown device for the cas 3, but you can link the device to the virtual XP and force it to install its 32bits driver.
Little complicated but it worked for me and save me of keeping the old vista PC!
Few more help:
Respect the order, install cas studio, put the console in full mode (seamless), start cas studio and then force the driver.
Hope I helped U.
Yaamaaan

[stroker]

Hi guys I have worked out how to get this working on Windows7 64 bit

Install Cas3 software
Click ok to about 4 errors
Click finish

Plug in Cas3
Driver installation fails

Open device manager in control panel
Right click on the very top line of the device tree (computer name)
Select add legacy hardware
click next
click next to search ....automatically....
click next to if you know the specific hardware model.......
select jungo form the list
click next
click have disk
click browse
point to c:\program files (x86)\duolabs\cas studio 8.7\drivers\vista64\duolabs.inf
click open
click ok
click next
click next
click install
click finish

unlpug Cas3 and plug it back in again
Cas USB driver should now install automatically

Ready to run Cas3 software

I hope this helps

[milano31]

sorry the only version available at the moment is Cas Studio 8.6c it works fine for windows xp but I dont know about windows 7 64bit if you have any problem juste tell us good luck

[Andrushenka]

sorry the only version available at the moment is Cas Studio 8.6c it works fine for windows xp but I dont know about windows 7 64bit if you have any problem juste tell us good luck

Latest software is 9.3.0. and works fine with windows 7!

[René]

it works not here when i will get underworld 218 on my cam :/ but i think it is my cam