Oscam Dm800 not working

[Cdd]

2009/12/09 13:52:26 2496 r02 No PTS, selected protocol 2: T0, F=372, D=4.000000, N=2

2009/12/09 13:52:31 2496 r02 standard baudrate: cardmhz=600 mhz=600 -> effective baudrate 38400
2009/12/09 13:52:31 2496 r02 ATR: 3F FD 13 25 XX XX XX XX XX XX XX XX XX XX XX XX XX XX XX 69 FF
2009/12/09 13:52:32 2496 r02 write to cardreader skyitalia:
2009/12/09 13:52:32 2496 r02 D0 74 01 80 01
2009/12/09 13:52:59 2496 r02 answer from cardreader skyitalia:
2009/12/09 13:52:59 2496 r02 failed to read 7401 cmd length (fd 13)
2009/12/09 13:52:59 2496 r02 card system not supported
2009/12/09 13:52:59 2496 r02 card initializing error


any suggestions ?

all mips versions tested, none working

SCam 3.55/56 straight picture ! 093b card

Regards

[rorothetroll]

make sure your boxid is correct. Also try rev 756 as some fixed were made in the pps code.

[Cdd]

make sure your boxid is correct. Also try rev 756 as some fixed were made in the pps code.

boxid absolutely fine, oscam totally not working ... scam working PERFECTLY also says BOXID (in sc_vid) is fine...

also tried 0919 card

error activating card ... oscam = really a no go :(

[Cdd]

boxid absolutely fine, oscam totally not working ... scam working PERFECTLY also says BOXID (in sc_vid) is fine...

also tried 0919 card

error activating card ... oscam = really a no go :(

Error activating card: -10
Error activating card: -10
Error activating card: -10

that's all i get, and sometimes ATR , but then failed reading card ...

Can someone please post 0919 dm800 +smartreader+ .server .conf. user files ? working ones for above setup .

THx

[arabeman14]

2009/12/09 13:52:26 2496 r02 No PTS, selected protocol 2: T0, F=372, D=4.000000, N=2

2009/12/09 13:52:31 2496 r02 standard baudrate: cardmhz=600 mhz=600 -> effective baudrate 38400
2009/12/09 13:52:31 2496 r02 ATR: 3F FD 13 25 XX XX XX XX XX XX XX XX XX XX XX XX XX XX XX 69 FF
2009/12/09 13:52:32 2496 r02 write to cardreader skyitalia:
2009/12/09 13:52:32 2496 r02 D0 74 01 80 01
2009/12/09 13:52:59 2496 r02 answer from cardreader skyitalia:
2009/12/09 13:52:59 2496 r02 failed to read 7401 cmd length (fd 13)
2009/12/09 13:52:59 2496 r02 card system not supported
2009/12/09 13:52:59 2496 r02 card initializing error


any suggestions ?

all mips versions tested, none working

SCam 3.55/56 straight picture ! 093b card

Regards

Hi,

are you sure that the right config is mhz = 600 ?
try using mhz = 375