The crow.drumer.and hawk dongle reciever

[eSC@pe]

crow loader and current firmware

[dark...lord]

Hi ...

i have one question :

is there a crow2 ( crow ii ) loader can be work at WINDOWS VISTA ??
because the (X-Dreamer Upgrade Tool v3) .... works only on WINDOWS XP


can anyone help ??

Thanks >>>

[dark...lord]

CROW_NSS6_20100804.zipCROW II_NSS6_20100804.zip


latest update for CREW and CREWII
04/08/2010

good luck

[ashnas]

Hi there,

Is there a separate software for Hawk II dongle receiver or will the software for crow work fine.

[dark...lord]

Hi there,

Is there a separate software for Hawk II dongle receiver or will the software for crow work fine.

It's the same
the same software works for Hawk II,CREWII and DrummerII
AND
the same software works for Hawk,CREW and Drummer

[arifram]

Hai all..... im new here.

im using the crow II.
I want to upgrade my crow by using Drummer upgrade ver 3.0


can sombody tell me


Port: ?
Bits Rate: ?
Parity: ?
STB select: master or slave?

operate mode: ?

we need to switch Off or switch On the receiver when to start upgrade?

Thank you

[ashnas]

Hi every one,
I connected my hawk II with the serial port device and ran the upgrade software.
I tried it with both the reciever turned off and on( upgrde by rs232 option) but it dosent connect i get a msg target not connected or target error msg!

Can any one please help me with this.

[dark...lord]

Hai all..... im new here.

im using the crow II.
I want to upgrade my crow by using Drummer upgrade ver 3.0


can sombody tell me


Port: ?
Bits Rate: ?
Parity: ?
STB select: master or slave?

operate mode: ?

we need to switch Off or switch On the receiver when to start upgrade?

Thank you

Port: you can define it by going to.. Control Panel>> Device Manager>> Ports(COM&LTP)
Bits Rate: 115200
Parity: Even
STB select: slave
operate mode: Upgrade

And you need to switch On after pressing CONNECT

[dark...lord]

Hi every one,
I connected my hawk II with the serial port device and ran the upgrade software.
I tried it with both the reciever turned off and on( upgrde by rs232 option) but it dosent connect i get a msg target not connected or target error msg!

Can any one please help me with this.

As far as i know ,,,
May be your Windows is Vesta

Upgrade software only works with WINDOWS XP

[arifram]

Port: you can define it by going to.. Control Panel>> Device Manager>> Ports(COM&LTP)
Bits Rate: 115200
Parity: Even
STB select: slave
operate mode: Upgrade

And you need to switch On after pressing CONNECT

Haaa


TQ dark.... its done successfully...