Millenium Card Programming problem

[Didden]

i use a phoenix infinity
usb/serial connection
portspeed 115200

after 20 30 time traying on 4 diffrent pc's
i have the card back working. with file mill10
when i flash mill13 then it go wrong
when he is flashing then he resset the card
then he says
art ** ** ** ** **
millenium card plus v.0.3.
no art
flash failt

and then he gives the same problems again.

do you need to erase the card first before you flash a new file

greetz

[zed44]

@didden

erasing the card is always better before putting new flash in it...

if the card is not recognized when you put it in the usb phoenix, try to put it out and clean the chip on it (with your shirt or whatever) before putting it back to the programmer

regards

[avicenne]

i use a phoenix infinity
usb/serial connection
portspeed 115200

after 20 30 time traying on 4 diffrent pc's
i have the card back working. with file mill10
when i flash mill13 then it go wrong
when he is flashing then he resset the card
then he says
art ** ** ** ** **
millenium card plus v.0.3.
no art
flash failt

and then he gives the same problems again.

do you need to erase the card first before you flash a new file

greetz

Hi diden

I read on millenium section there are some old files renamed and would'nt work, personnally i use mil10 for official receiver and mil12 for other receiver and evrything is fine and work.

Bye

[ee4649]

i have also a problem,i put my card at phoenix at 3.57mhz but the loader says Please insert your card ....,i cannot solve it,any solutions?
i cannot program it....

look my programmer:



any help plz?

[Didden]

i have also a problem,i put my card at phoenix at 3.57mhz but the loader says Please insert your card ....,i cannot solve it,any solutions?
i cannot program it....

look my programmer:



any help plz?

have you selected card connector No??


greetz

[-magnum-]

have you selected card connector No??


greetz

what name to your programmer like carmaster but cardmastere not have mode phoenix---the proble is programmer more explication for your programmer and cards where you buy it i'mind contry regards mag and have you net frame work on you rwindows
regards mag

[Cyb3rc0m]

have you selected card connector No??


greetz

YOU should use Real COM PORT virtual one she didint work with the loader !

[f0c2009]

I program my millenium card with a Millcard12 and i don't updated with a Millcard14.

I used a infinity usb smart
With COM10 Phoenix 3,579 normal or 2xfast
I selected MilleniumCard loarder with port 10 fast speed
Conect
Resetting Card ...
ATR: 3F ** ** ** ** ** ** ** **
APPLICATION LOADED.

this is a problem
i select program with a file millcard14 aes
and....
SMARTCARD PROGRAMMED ERROR!

is the solution ERASE APLICATTION first and before programm????

Thanks many

[dirty66]

Set the loader on SLOW SPEED, erase the old Aplication and programm card with the new file !

[wikisat]

erase
load mil14
load mil14aes

tested and worked
smart should work on fast mode