SRT jtag store

[Carbian66]

Hi @all ; I have demaged my Strong 6350. There is only blinking "----" and "dnld". I was looking for a Dumpfile for Jtag, but i cant find one. Did you know something about this receiver ??? How to ractivate the RS232 ??? I think it will be only one solution - JTAg . Can anybody help me about this problem please ?? thx and best regards.

[adam_gobi2000]

jtag for strong 4500 ci?

[urmans]

m29w160et
Strong 3620
Strong 4630 m29w160bt

[slowly]

pls some one help me , my strong 4651x is hang is not booting no/off

[matei.luci]

1. Connect the receiver to a computer through RS 232C interface.
2. Receiver power off.
3.Start the SRT Loader and select Firmware tab.Browse and select the location of the new firmware 150p for your receiver.
2. Click Start Download Firmware
3. Start the receiver.

Next time pls. use the chat section.

(Thx Urmans - for me it worked)

[adewale]

Attention :

First you must be provide JTag cable. this is important.

JTag cable use Printer port while Upgrade cable use RS232 port.


Then use this program to ReFlash your receiver.

goodlock

dear Top gun, there is something am missing here.is it that the jtag cable consist of USB head one side and printer head at the other side or how, and on what interface of the computer and the receiver am i to do the connections? Am in serious trouble, please help me out. Thank you sir

[TOP.GUN]

dear Top gun, there is something am missing here.is it that the jtag cable consist of USB head one side and printer head at the other side or how, and on what interface of the computer and the receiver am i to do the connections? Am in serious trouble, please help me out. Thank you sir

JTag connector head one side and printer head one side.

[adaroubala]

Please, how to build the jtag on the receiver srt 4653X. I havn't seen place where to weld the jtage on.

Thanks

[slowly]

pls so one help, how to down load jtag into strong 4620x receiver

[lolo2]

please help me for jitag 4620x