programming TITANIUM CARD with CAS Interface 3Plus

[BebeTheGreek]

Hello friends

I have a problem programming my Titanium Card.
It’s a Titanium card 3.25 or 3.4 (I’m not sure wich one) and I’m trying to program it using CAS Interface 3Plus.
This is what I do: I open the CAS Interface Studio 8.7 and set Phoenix Mode 3.68. Then I open the Titanium Card Progger (I’ve tried several versions of that programmer), put in the card and it appears the following information: ATR: no ATR, unsupported Titanium OS found. And then I press the Erase button and on the screen appears ..sending TRAPCODE.. but nothing else happens. I keep waiting for about 3 hours and it still says ..sending TRAPCODE..
I’ve even tried to switch off FIFO buffers, but it’s still the same problem.
I’ve red that I should open some programs like Microsoft Office to slow my PC down. Well I did so, but still nothing.

About my PC: WindowsXP Professional, Service Pack 3
Pentium 4, 2,6 GHz
512 MB RAM

PS do I have to put the card into the CAS interface with the chip UP or DOWN? (I’ve tried both, but am still not sure)

Thank you.

Later

[cascadero]

put inside with the chip down and then press slightly on the surface of the cas3plus, so the card-chip will get better contact to the reader. Try it several times. For me it works