what do it mean that gamma card is locked

[Cyb3rc0m]

To virginize a gamma card you need the right script.....the tc of the card and then the OS to load it
No one have done that successfully when a fake OS 5.3 was out with a script from 007.4(he has report that is fake)
If you put wrong the tc 3 times then the card is dead

for sure you should keep the Os Zone on card free (never touche that (part witch control intern card clock, voltage ... ) :) and just to reset the other Code Lines ..(i have do this with Card with Os and she she succeful unlocked )
maybe it is a little be hard ...but i find the way...

try to do this
open your programmer
set it at phoenix mode
choose 6 mhz(to my pc) ( dont use an Virtual COM port!!)
insert card and connect serial cable
open the unlocker
tick 6 mhz
tick the com port
wait little time and atr is back and card unlocked
Dont send String.... to the card

last advice verify File before put it into card Fake File always Lock cards ;)

[slim71]

I have followed the insturaction.

still i have this msg : card is locked.

used the unlocker ver 1
put is 6 mhz
mouse is on 6 mhz
com port 1

then ATR = 3b 2b 11 00 10 80 00 02 and some symble where there beside it and the numbers did not change...

my programmer is phoenix mouse.... i have an old multi programer 2000xl but have not used it in a long time....

[douros]

I have followed the insturaction.

still i have this msg : card is locked.

used the unlocker ver 1
put is 6 mhz
mouse is on 6 mhz
com port 1

then ATR = 3b 2b 11 00 10 80 00 02 and some symble where there beside it and the numbers did not change...

my programmer is phoenix mouse.... i have an old multi programer 2000xl but have not used it in a long time....

Mate give a try with these TP and follow the directions......post#5
http://www.satsupreme.com/showthread...Card-is-Locked
Good luck