Force 1145S and Channel editor 1.5.5.0

[Jambo]

Hello to All,

Have a problem with uploading of the channel list with the channel editor 1.5.5.0 to the 1145S, the editor states "receiver do not answer".

The software is properly installed, as well as drivers, the serial cable is also ok, and the receiver is placed in the data (f128) receive position.

Have tested on 2 different PC's and it is the same outcome, no contact with the receiver.
Am using the same stuff on a 1030S, and there it is working fine, without any problems.

Would appreciate some assistance and new ideas, on how to proceed with this matter.

Thanks in advance.

Cheers,
Jambo

[skidy1]

hi i 2 have a 1145s i had to unplug an reinsert about 6 times,posabley dirt and dust as the port rairly gets used.