Boot problems edision 2100fta + jtag

[orbitcam]

I have been searching many threads about this problem whith the receiver stuck in boot mode , I have also tried all the fixes I can find all over the net, but nothing is working , there is no way anything can be done via the serial port as there is no communication between the stb and the computer , I think the only solution is to Jtag and here is the problem , I can find no Jkeys software which lists either the IRD model or the flash ( LH28F160 BJE TTL 90 ) made by sharp so the jkeys program will not function,
does anyone know of a JKEYS .DEF file which has this receiver and flash

any further help appreciated as I think this is going to be a BIG problem whith this range of receivers .

greetings from spain .

[Hyujin]

Hi,

In the attachment you will find Jkeys.def and ED2100-Tvcabo.bin prepared to Jkeys.
Configure IRD Model to COMAG in Jkeys.

Good luck.

[orbitcam]

Hi,

In the attachment you will find Jkeys.def and ED2100-Tvcabo.bin prepared to Jkeys.
Configure IRD Model to COMAG in Jkeys.

Good luck.

Thanks for that, however this box uses the sharp LH28F160 BJE TTL 90 flash chip which is not supported in the comag ird setting any idea how to change it so it is configured to the correct flash for this box ?

[jays]

Hi,

In the attachment you will find Jkeys.def and ED2100-Tvcabo.bin prepared to Jkeys.
Configure IRD Model to COMAG in Jkeys.

Good luck.

Thanks to U for all the help