I cannot programm my Matrix Reborn.

[Sat7]

Dear All,
I have some problems with my this new Matrix Reborn Cam.
I just cannot program it. I use Cas Interface 3 to program it,
but when I insert it inti the receiver then still getting message
that there is No Nodule into the receiver,
Any suggestions please.....?

[RobertH]

Dear All,
I have some problems with my this new Matrix Reborn Cam.
I just cannot program it. I use Cas Interface 3 to program it,
but when I insert it inti the receiver then still getting message
that there is No Nodule into the receiver,
Any suggestions please.....?

@Sat7

- Fake Reborn?
- Try program the cam with another firm and see if it is reconized
- Try with the last Gxmax version

.

[Asus 1]

Dear O.M you must see zcas in your receiver by comm interface .

[RobertH]

Yes Sat7, you must see "zcas" as @Asus 1 said.
Or you have some kind of conflict...
Or your Reborn is not ok...

What receiver do you have?

[ambo]

I just recently got two of them, one ok and one not. Do you get some soort of error code that cas3 puts out and followed the link? It is stated there that there is a poor soldered connection on one of the last pins. My problems seems to be with the pcmcia connector or pin as indicated in the cas3 webpage.