Oscam (newcamd) /w local cards<-> Oscam (newcamd) <-> CCcam clients

[rackz]

I am trying to run Oscam locally with local cards and then have thsi so called OSCAM 1 connect to OSCAM 2 without local cards. Finally I want my clients to connect to Oscam 2 through CCCAM in their boxes and servers.

So I have 4 local cards in my OSCAM 1. They are all in Omnicard USB 3121 readers and they work fine.I have set up a USER for OSCAM 2 to login.
In OSCAM 2 I have setup a READER with the NEWCAMD protocol. This suppose to come to live when a client asks for ECM's by switching from one channel to another.

The client is actually a dreambox in my house but could be anyone. The only thing I require is that my clients all use CCCAM. So they connect to OSCAM 2 using a C line (c: x x x x . d y n d n s . c o m 12000 user pass)

When this clients zaps it connects to OSCAM 2 and because OSCAM 2 does not have any shares OSCAM 2 will connect to OSCAM 1 to find my local card.

Problem :

When zapping to a channel on the client/box no connection is established between OSCAM 1 and OSCAM 2 so no card can be found. In OSCAM 2 I can actually see the client be logged in and switching channels.

I have aso tried connecting the OSCAM 1 and 2 using cccam. Same problem.

Its pivotal that the setup remains the same in other words :

oscam 1 (with local cards) based in country one - oscam 2 no local cards based in coutry two - cccam clients (everywhere :))

For your info :

in OSCAM 1 :

[account]
user = xxxxx
wd = xxxxx
group = 1 (same group as the reader for my local card)
cccmaxhops = 4
cccreshare = 5
cccstealth = 1
keepalive = 1

in OSCAM 2 :

[reader]
label =
protocol = newcamd
device = xxxxxx.xxx.nl,10000
key = 0102030405060708091011121314
user = xxxxxx
password = xxxxxxxx
group = 1
blockemm-unknown = 1
blockemm-u = 1
blockemm-s = 1
blockemm-g = 1
audisabled = 1


ook in OSCAM 2 :

[account]
user = bedroombox
pwd = xxxxx
group = 1
cccmaxhops = 4
cccstealth = 1
keepalive = 1

Any ideas ??

Regards
Rackz

[CapNCooK]

Better use the camd35 protocol when having 4 different CAID's in Oscam1's readers.
If they are all from one provider, newcamd will do the job.

about your config:

- ccc* options are not relevant in newcamd / camd35
- if Oscam1 contains one CAID, you should specify this CAID and IDENT in the reader on Oscam2

how did you define the newcamd port in Oscam1 ? (post oscam.conf)