Need Guides From Experts-connection Error On Mvision

[georgekamal]

DEAR FRIENDS and experts ,please any one guide me and help me .......my receiver Mvision F-1000 receiver not connected with box loader and unable to upgrade a new software and remote not accessing and also no function on front panel buttons...caused , upgraded the wrong software.....what s the solution?need jtag? if yes ,please guide me how to recover the box?(i have simple jtag cable) any-help.gif any-help.gif any-help.gif any-help.gif any-help.gif

[GUSJA]

Dear friend i think that you don't need j-tag.

Try with this

Connect your stb on your pc with null modem cable
Turn off your stb from the back bottom
Then run the boxloader 1.2
Choose the right unziped firmware
Then press ok
After 2-3 seconds turn on your stb

Normally this procedure is the solution.

If it don't work in the first time try and try many times. In this case is very important the timing.

[CaptainHowdy]

I would suggest you reload the ORIGINAL factory flash first...then load your upgrade files.

[georgekamal]

Dear friend i think that you don't need j-tag.

Try with this

Connect your stb on your pc with null modem cable
Turn off your stb from the back bottom
Then run the boxloader 1.2
Choose the right unziped firmware
Then press ok
After 2-3 seconds turn on your stb

Normally this procedure is the solution.

If it don't work in the first time try and try many times. In this case is very important the timing.

yes i have done and succeed by ur guidens ,thankx a lot.....