cache-ex oscam to oscam

[CapNCooK]

Thanks again,

Supposed no i didn't set CSP parameters, can you tell me what CSP parameters ???

I still need to add this to the CACHE-EX Tutorial..

You need to enable CSP (just as dummy-service) to enable csp parameter wait_time.
This wait_time will hold all readers for ...ms to wait for incoming cache3 on a request.

Without.. a normal reader will be involved at every request, even when finally answered by cache3.
So to make long story short..

If you run one CAID on your server.. set this value a bit higher then the avarage response
time from card. Also... This needs to be a multiply of 50. So 0,50,100,150,200,250 etc..

If you got freezes after setting this.. Lower the value by 50 and try until it's freeze-free.

[_pinky_]

You need to enable CSP (just as dummy-service) to enable csp parameter wait_time.
This wait_time will hold all readers for ...ms to wait for incoming cache3 on a request.

CapNCooK can you tell me where i should put this csp parametar ???

at normal oscam or cache oscam ???

Thanks again,

Pinky

[CapNCooK]

just enable CSP thru webIF.

Set ip: 127.0.0.1 / Port:64000 / wait_time: 200ms (to start with)

[easyyu]

I still need to add this to the CACHE-EX Tutorial..

You need to enable CSP (just as dummy-service) to enable csp parameter wait_time.
This wait_time will hold all readers for ...ms to wait for incoming cache3 on a request.

Without.. a normal reader will be involved at every request, even when finally answered by cache3.
So to make long story short..

If you run one CAID on your server.. set this value a bit higher then the avarage response
time from card. Also... This needs to be a multiply of 50. So 0,50,100,150,200,250 etc..

If you got freezes after setting this.. Lower the value by 50 and try until it's freeze-free.

Hi..I'm using v 7963 with cacheex mode3.
Do I need still this settings or it is now repaired in latest version?