Em-tech 400irci

[posejdon]

Czy ktos mi moze pomoc w ozywieniu tego tunka,potrzebuje dumpa z tego tunerka.

[cr3pt]

posejdon, a skad to wyrwales?
pogrzebie, ale najpierw opisz "objawy"... Bo nigdy nie wiadomo....

Pozdro
Cr3pT
FunFiles Team

[posejdon]

mieszkam w grecji i ogladam ich kanaly, ma wbudowane irdeto stad ten tunek.
objawy,same 88:88 na wyswietlaczu i nic wiecej

[cr3pt]

I nic a nic na ladowanie czegokolwiek??
bo dla mnie to soft uwalony....
Zaraz poszukam czegos i uploadne..

[cr3pt]

OK - a oto software
1) rozpakowac i zainstalowac
2) dzialac
3) jak potrzebna pomoc (z ladowaniem) napisac mi info tutaj w czym pomoc...

proste?

Firmware jest orginalne - nie zadne patchowane

Best Regards
Cr3pT
FunFiles Team

[posejdon]

wszystko to mam ale RS232 nie dziala potrzebuje dumpa.
w tym jest problem

[cr3pt]

OOO... sorrki - nie doczytalem - zaraz polookam - moze cos znajde
Momencik...

PS: a pytales na shoutbox'ie?

[PAN]

Download Procedure for eMTech and Homecast receivers
First of all, download "HCUpgrade.zip" and follow these steps-

1. Copy the "HCUpgrade.zip" file - compressed by winzip program.
(We Recommend make new directory: C:\HCUpgrade)

2. Extract HCUpgrade.zip in the "HCUpgrade" directory on your PC.

3. Press the "setup" file, then you can see the set up procedure.

4. Follow the installation instructions.

5. After setup is finished, you can find the HCUpgrade program in the program files.
(press "Start" -->"program" -->"HCUpgrade")

6. Download the software for the relevant model receiver from our site. This will be
a binary file (.bin) or an .sgn file.

7. Copy the upgraded new software file in proper directory.
(We recommend to make new directory: C:\HCUpgrade\Software)

8. Run HCUpgrade and select the Comms port you wish to use, either Com1 or Com2.

9. Disconnect the receiver's AC power cord.

10. Connect an RS 232 cable (Crossed type NULL MODEM CABLE- Pin No. 2 and 3) between PC and Receiver.
(RS232 should be connected on the Com port youhave selected in HCUpgrade on the PC)

11. After you start HCUpgrade, select 'Download' in the 'Mode' menu, and 'Prog Data' in the 'Tyoe' menu.
Go to “BROWSE” and select the software for the receiver you wish to upgrade. The file can be .bin or .sgn.
Select “DOWNLOAD” then press the start button.

12. Connect your receiver to the mains and turn on the mains power.

13. Wait unitl the download is complete, then you can use your receiver.
----------------------------------------------------------

[posejdon]

receiver is dead !!!!!! if you have ,please give me flash dump

[PAN]

cannot help you sorry



http://www.masterixweb-italy.com/new...oad_emtech.htm




Best Regards


PAN