Thank you gimecsa, didn't knew a new HoT was released. Yes now we need DSR 9500 EMU Ed54. And thanks the ToH HoT team.
Thank you gimecsa, didn't knew a new HoT was released. Yes now we need DSR 9500 EMU Ed54. And thanks the ToH HoT team.
Update #2 to the Humax Tray Suite,
Updated:
- DSR 9500 EMU Editor v5.4,
- HDFSmart v1.8
ATTENTION: Make sure you have update #1 installed!
Regards
to send keys use the following prog
SammyReadWrite
with the ram included
you make read then write
if you want to change keys
use DSR_9500_EMU_Ed54_CW
then save your file and send it again with sammy read
please note during sending file your humax nust be on standby mode
but some times it accept while you are watching scarmeled channel
regards
ghamdan
www.jo1sat.com
sorry for late reply but I have been away, Thanks for reply but I have tried that and same still applies, I have noticed that the dots are static and not flashing as usually appears when channel settings not good
Try a All Flash Reset, and then the latest firmware, settings...
And if this doesn't work I recommend, with caution, reupload the loader.
Let me know if you need help doing this.
ghamdan are you working on the r3x crypto software?amstrad and tecnosat 9000 ultraOriginally Posted by ghamdan
Hi, Have done as you suggest and folowed all directions to the letter still no joy, If you could instruct me on loader procedure I will try that please
Humax Z Board
Hi All, I wonder if anyone can help me, I have a 5400Z which has the old HIC Loader (Not Flashable) I am looking for someone that can and would do the z board modification for me, My eyes and hands are not what they used to be and I do not feel confident enough to try it.
Thank You
Your loader is H2.08.
Upload the file in attachment. It's the Boot loader and System ID.
use HZU 2.0, you can find it in Humax tray suite
It Looks like I may have a bad Problem, It is still the same
Posting Permissions
