How to Update smart cards Viaccess, Conax, Irdeto, Seca, Nagra, CryptoWorks etc by The Last Drakkar
There are two very simple ways to update permissions on your card.
1.First way to send permissions to the card is by the file:
-run the program
-click "Connect"
-go to the "BinToTxt" (1)
-click "Open dirty Bin File" (2) or "Load Cleared Data" (2) , according to the form in which we have written EMM'y and select the file
program will inform you - correct file is loaded
-in the "Select query type" (3) select 'Card (Serial,SA)'
-click "Find and Show / Show All" (4)
autoupdateEN.jpg
2.Second way to send permissions to the card is by the logger:
-run the program
-click "Connect"
-go to the "Logger" (1)
-in the "Telnet Connection Settings" (2) enter the relevant data
in the "Host" enter the IP of our receiver, the rest of the settings change if we have custom
-click "Get PIDs" (3) and select the PID to which the provider sends permissions to our card
-in the "Export results to" select 'Card (Serial,SA)'
-click "Start" (4)
autoupdateEN2.jpg
In both cases, the program will automatically read the card Serial and PPUA/CHID and will send the appropriate EMM's
The "Custom Card Filter" option is to read filters (serial / PPUA / CHID) from the card and to manually add your own filters
The "Check Change" is used to check what has changed on the card after sending the instructions
-In the "BinToTxt" program checks after every instruction
-In the "Logger" program checks after user choose how much instruction
This description is intended to assist subscribers in cases where the receiver does not pass our rights to receive subscriber card
Reply With Quote
