Loadbalancing and Oscam Config support needed!

[SupremeOne]

I've managed to everything working properly except Digiturk. When I use Digiturk (balci) as cccam in my dreambox 500HD I've no lag and lower ecm. But when I use it in oscam server. I have sometimes very high ecm and lag. I make use of oscam.services for Digiturk like;

caid:0D00
provider:
srvid:2300,2012,1BF4,200A,66AA

etc etc

I use lb white list also and I've blocked every other caid with "!" and still get too many timeouts.

Like I said when I use the cccam in my own box it's working much better.

[turbopower]

Do you have more than one Digiturk local cards?

[SupremeOne]

Do you have more than one Digiturk local cards?

No I don't have any local cards of Digiturk all of them are peers.

[turbopower]

The oscam load balancing is created mainly for local cards, with proxies is better to be turned off.

[SupremeOne]

The oscam load balancing is created mainly for local cards, with proxies is better to be turned off.

Ok I've set lb mode to 10 . What about cw cycle check? Should I enable it.

[turbopower]

If you using cacheex then my answer is yes. Get rid of all loadbalancing settings, and ask your peers to provide you camd35 and you will see the difference.

[SupremeOne]

If you using cacheex then my answer is yes. Get rid of all loadbalancing settings, and ask your peers to provide you camd35 and you will see the difference.

Ok thank you very much for everything!

Could you take a look at my oscam.conf. Is there anything I can remove or change here like retry limit? :

[global]
logfile = /var/log/oscam.log
fallbacktimeout = 1600
unlockparental = 1
nice = -1
maxlogsize = 100
waitforcards = 0
block_same_ip = 0
block_same_name = 0
lb_mode = 10
lb_save = 100
lb_reopen_invalid = 0
lb_retrylimit = 1200
lb_savepath = /usr/local/etc/stats


How should I make use of oscam.services?

I've marked every caid on the left column which the peer provides and blocked every caid in the middle which I don't want to get from the peer and also marked every caid on the right column called lb whitelist.

Should I also make use of ecm whitelist?

Anyway thank you very much

[SupremeOne]

If you using cacheex then my answer is yes. Get rid of all loadbalancing settings, and ask your peers to provide you camd35 and you will see the difference.

My peer said that he used camd35 once but with too much freezes or is this fixed with the newer oscam versions?

[turbopower]

I am not using oscam for cacheex anymore. Most of the people prefer camd35, though.

[Chrisabel]

Set lb_retrylimit for the digiturk caid. Monitor your log wich ECM times are good. Then set the lb_retrylimit around those times.

Set the logfilter to the desired caid. Monitor freeze-free ecm times. Calculate the average. Put it in the config like <CAID>:<TIME IN MS>,<ETC>

Hope this will help you out. Good luck.