Bonjour , je n'arrive pas à flasher le zehnder 3010ci annoncé comme clone fte ,je ne suis pas novice mais là on dirait qu'il ne se passe rien ,merci de m'apporter votre aide.
Bonjour , je n'arrive pas à flasher le zehnder 3010ci annoncé comme clone fte ,je ne suis pas novice mais là on dirait qu'il ne se passe rien ,merci de m'apporter votre aide.
regarde son boot de demarage on ou boot et les infos sur ce demo ; et y'aura quelqu'un quiva t'aider
amicalement
jai ca si tu es interressé Zehnder DX3000CI original Firmware
Je n'est pas les infos là ,je suis à mon taf ,je regarde cela ce soir .
Zehnder DX3000CI Original Firmware_111007
INSTALLATION:
1st Combine the RS232 interface of your PC's DX3000 with the receiver via a serial AT-AT connector cable with the following pin assignments:
DX3000CI PC 9-pin. Female 24-pin PC. Jack
2 PIN PIN 3 PIN 3
PIN 3 PIN 2 PIN 2
5 PIN PIN 5 PIN 7
2nd Plug the power plug the receiver into the outlet.
3rd Turn on your receiver on the power switch on the back of the display of a 'boot'. Then on standby (red lamp lit).
INSTALLATION:
1st First install the communications program "ZehnderEdit" on your PC, by using the file "ZehnderEdit_install.exe".
2nd Start from the proposed directory C: \ Zehnder, "or your selbstgewälten directory with a double click the PC program" ZehnderEdit.exe ".
3rd Confirm the menu item to the used serial COM port (COM1 or COM2).
4th If you are a new version aufspielen want to start. (If you have your current program list on the PC
Want to start the warrant.
5th Select the desired upgrade file 'rom.bin' from the corresponding directory and start the transfer
'Open' or double-clicking on the file name. (It seems the message "Trying to connect ..." in the title bar of the program)
6th During the data transfer shows both the PC as well as the receiver in the display of the current status
Process, e.g. At 'd.052' is 52% of the transfer.
7th After completion of the transfer wait until the "good" in the device screen.
ATTENTION!
Never disconnect the power cord during the transmission process, or during the receiver internally still employs
(Recognizable by the characters in the display device), because otherwise the memory module can be damaged.
8th If someday the error message "ERR" on the display device, or "time out" on the PC, there is a transmission error.
Check again if the right interface COM1 or COM2 have chosen or you have to change the attitude "Sleep Time".
Begin then again at the 1st Step.
9th In conclusion start the new receiver, it briefly on the power switch off and back on.
10.Verlassen ZehnderEdit the program with the command
J'ai trouvé ca
la version logiciel : s2.61.pa
version hardware : B1.25.H00.D0.SC2.MB029
Bonsoir ,j'ai essayer d'installer le fichier ci dessus en faisant traduire le tuto mais pas moyen ,merci de votre aide je gallére.
Posting Permissions
Reply With Quote