18.12.2023
version 2.04 of EPGRefresh
Changes:
* Bug fixed when <After automatic EPG update> = <Standby> (had to be switched on twice afterwards)
* Additional setting parameter <Even if receiver is switched on?> as a subselection to <After automatic EPG update>
This allows you to set whether the previous setting should also be applied if the receiver is switched on at the end of the update or whether it remains switched on in any case.
The suggested value is 'deactivated', which corresponds to the previous treatment of the setting <After automatic EPG update>.
* Change to <Show message when update starts/ends>
Even if this is activated, the messages are only displayed if the receiver is switched on at the time the message is issued (i.e. not in standby).
* Message 'The receiver may have started up automatically to update the EPG. It is recommended to do this in standby. Go to standby now?'
This message occurred when the receiver restarted automatically within 10 minutes of an (attempted) EPG update. You can then choose within 15 seconds whether you want it or not. This sometimes caused the box to be switched on as a result of the message and, if the HDMI-CEC control was set up accordingly, the TV and amplifier were also switched on. It's basically an alarm clock in the middle of the night.
It is now defined that - if <Show message when update starts/ends> is deactivated - this message does not appear.
Likewise, the message no longer appears if <Force update> is activated. In this case there is no need for forced standby.
If problems arise, please provide feedback. If none of these occur, I will put the new version on Feed+.
thx WeFraJo
screenshot_2023-12-18_14-44-45.jpg
Reply With Quote