[HOW TO FLASH] how to flash Opticum Odin Twin
To flash the Opticum Odin Twin, you are working with a classic Broadcom-based Enigma2 receiver. The hardware is identical to many “Odin” branded boxes, so the key is ensuring the bootloader finds the specific folder path.
Preparation
- USB Drive: Use a small USB 2.0 stick (max 8GB) formatted to FAT32.
- Download Image: Ensure you have the firmware for the Opticum Odin Twin (OpenATV is highly recommended).
- Extract Files: Unzip the archive. You will see a folder named odin.
- Copy to USB: Transfer the folder to the root of the USB drive.
- Structure: USB Root -> odin -> twin -> (image files: kernel.bin, rootfs.bin, etc.).
The Flashing Process
- Power Off: Turn the receiver off using the physical switch at the back.
- Insert USB: Plug the stick into the front USB port (located behind the front flap).
- Power On: Flip the rear switch to ON.
- Initiate Flash: * Watch the front panel display carefully.
- When it shows “UPDT” or “Update?”, press the OK button on the front panel (behind the flap) immediately.
- Wait: The display will cycle through the flashing progress. Do not interrupt the power.
- Complete: The receiver will reboot itself when finished. Once you see the setup wizard on your TV, you can remove the USB stick.
Troubleshooting
- Folder Hierarchy: Ensure there isn’t a “double folder” (e.g., odin/odin/twin). The odin folder must be at the very top level of the USB.
- Force Update: If the button doesn’t trigger the update, find the file noforce in the twin folder and rename it to force. This will automate the flash.
- USB Selection: Older Opticum boxes can be very picky. If it skips the update and boots normally, try an older USB 2.0 drive.
Reply With Quote