[HOW TO FLASH] how to flash Edision Optimuss OS3 Plus




Flashing the Edision Optimuss OS3 Plus (Step-by-Step)
1. Prepare the USB Drive

  • Format: Use a high-quality USB 2.0 stick (FAT32 formatted). This MIPS bootloader can be picky, so a 4GB or 8GB stick usually provides the highest success rate.
  • The Folder Path: Extract your chosen Enigma2 image (OpenATV, OpenPLi, etc.). The root of your USB drive must contain this exact folder:

    • USB_ROOT/os3plus/

  • Verify Files: Inside the os3plus folder, you should find:

    • kernel.bin
    • rootfs.bin
    • imageversion

  • The “Force” Shortcut: If you want the flash to start automatically, rename the noforce file to force.

2. The Flashing Procedure

  1. Power Off: Turn off the receiver using the physical power switch at the back.
  2. Insert USB: Plug the stick into the front USB port (hidden behind the flap) or one of the rear ports.
  3. The Trigger:

    • Turn the power switch back to ON.
    • If using force: The front VFD display will immediately show “Flashing” or progress text.
    • If using noforce: Watch the front VFD display. When it shows “CONF” or “USB”, press the OK button on the front panel (behind the flap) or the Power button.

  4. Wait: The VFD display will show the flashing status. This typically takes 3–5 minutes. Do not power off during this process.
  5. Finish: The receiver will reboot automatically once the image is written. You can remove the USB stick when the first-time setup wizard appears on your TV.