[HOW TO FLASH] how to flash AXAS E4HD




The AXAS E4HD is the original HD model in this series. While it is older than the Ultra or Hybrid versions, it still uses a Broadcom chipset, which means the flashing method is consistent with the standard Enigma2 “folder-on-USB” approach.
Step 1: USB Preparation

  • Format: The USB stick must be FAT32. For these older models, a smaller USB 2.0 drive (under 8GB) is the most compatible.
  • Folder Structure: Unzip your image (e.g., OpenATV). You will see a folder named axas.
  • Target Path: Inside the axas folder, the subfolder must be named e4hd.

    • Path check: USB_DRIVE:\axas\e4hd\
    • Files: Ensure it contains kernel.bin, rootfs.bin (or rootfs.tar.bz2), and imageversion.

Step 2: The Flashing Procedure

  1. Full Power Off: Turn off the AXAS E4HD using the physical power switch at the back.
  2. Insert USB: Plug the drive into the front USB port (usually located behind the front flap).
  3. Boot & Trigger:

    • Switch the rear power toggle to ON.
    • Watch the front panel LED or display. When it displays “Update” or a prompt to press a button, quickly press the Power button on the front panel.

  4. Flashing Progress: The LED will likely blink or the display will show “Flashing.” This takes about 3–5 minutes. Do not power off during this time.
  5. Reboot: Once finished, the box will automatically reboot. Remove the USB drive immediately so it doesn’t re-enter the flash cycle.