StreamDriver - DVBS2 driver 0.1.4
StreamDriver - DVBS2 driver 0.1.4
StreamDriver - DVBS2 driver 0.1.6
StreamDriver - DVBS2 driver v0.1.9What's new
TBS 6903x direct tune (TbsPcieDirectTune=1): non-TS carriers are delivered like the vendor driver does. A GSE or generic carrier (MATYPE TS/GS other than 11) now gets the vendor driver's raw-BBFRAME delivery set; ST's default left a 2.3 MS/s GSE carrier at about 1 Mbit/s with 40% of packets flagged TEI, now 2.6 Mbit/s and clean. TS carriers keep ST's delivery. StreamDriver undoes these registers before the next search, tune, scan or vendor-driver tune and at close, so the next carrier never inherits them.
TBS 6903x vendor path: a TS that stops right after lock is recovered. The vendor driver sometimes delivers TS for about a second after the graph starts and then nothing, while still reporting lock (also in 0.1.8). After lock StreamDriver checks that samples keep arriving (window scaled to the symbol rate, 2-10 s) and otherwise stops the graph and tunes once more. Live: 5 of 5 stalled starts recovered.
TBS 6903x blind scan: windows that reached packet lock on a TS carrier wait up to 3 s for output instead of 1.2 s (a real 30 MS/s carrier was missed before). Vendor-path SignalInfo polling shares one carrier reading between the readback and the C/N and backs off after failures, separately for each, so a flaky register bridge no longer costs seconds per call or hides the readback.
TBS 6903x vendor features (DiSEqC, signal, stream selection, LNB power-off) no longer require DirectControl=1; the features that are configured but unavailable are logged at open. After a client's own committed-switch DiSEqC command, BDA tunes with TbsDiseqcLnbSource=-1 keep that port instead of switching back to port A.
TBS5927 / 5927SE: the split I2C read rejects short replies (AVL identity read twice and must agree); EEPROM reads use sequential transfers (512 USB transfers down to 16); the authentication check no longer runs on every Open.
Transport and API: GetDeviceState and GetTransportHealth work during scans, tunes and callbacks without waiting for the session; the bitrate is no longer reported after packets stop (staleness follows the stream's own sample spacing, so slow carriers get a valid rate); a discontinuity flag on adaptation-only packets is honoured; the TS path no longer takes a lock per packet or copies whole samples.
StreamDriverTest: --bundle hashes the TS file actually written, handles non-ASCII folders and never deletes the DLL's own INI; --scan-channels tunes each hit with its measured parameters; a capture whose TS stops after the settling window now fails; --no-signal-poll with --isi is rejected; packet counts are printed per poll.
Version 0.1.9 in the DLL resources, project and manifest.
Behaviour changes
GetIdentityStatus: a measured symbol rate that differs from the request is reported as MEASURED with relation DIFFERS (was READBACK_REJECTED); a qualified lock with an empty readback sets neither READBACK flag; the readback is cached per tune request (accepted readbacks only).
GetTransportHealth: BitrateBps is 0 whenever SD_HEALTH_BITRATE_VALID is clear.
GetDeviceState may report the open/cleanup/device-lost answers last read while another call holds the session.
SessionGeneration no longer increments on a StopDVB with no open device.
Validation
Release builds of both architectures; unit, API, LLA fake-chip and fake-backend suites pass (see the commit message for the CTest run after packaging).
Live on a TBS 6903x (tuner 0, C band and Ku band) and a TBS 5927SE (C band): tunes, blind scans, the direct-tune GSE delivery, the stall recovery and the debug-log path on a tested device (no file is written; Log=1 unchanged). The TBS 6909x and 6983 debug log is tested offline only (no card available).