Stealth 2.53 problem

[sag]

I tried to install in Diablo cam light the firmware stealth 2.53 but in 72% the installation stops and pops up the message “operation error”.
Can anyone, please, make a backup of the firmware of his cam (2.53 or older) to install it with restore backup to cas interface 2.
Thank you in advance!!!

[mb1]

Try formating the cam first

mb1

[sag]

I have made a format, but the problem remains. Can you sent me a backup of the firmware stealth 2.53 of your cam.

[seadiver]

When you format the Diablo it clears everything in the cam.
Please remember Diablo is a very temperamental.
Try downloading stealth 253 again (remove the one you could not use) and program the cam again if the problem still there try again and again.

Try a different USB port and USB cable.

Cas 2 is a little old but it should do the job, i was getting few problems using Cas 2 like having to program the cam few times in the end it did the job since i change to cas 3 plus only once i had to program the cam again in 12 months and it was the Dragon cam.

It helps if you mention your set up.

[sag]

Problem o.k with cas interface 3 +