T-Rex twin mod upgrade

[Momba0]

I have a t-rex twin module cam, rev 1.0 and a cas3.
Is it possible to upgrade this cam? and if so, how do i go about doing it.
Could someone please send me instructions on how to do.
Thanks in advance.

[Ichijoe]

Ok with the Dragon and or T-Rex / T-Rex Supermodule and I'm susspecting the GigaCAM too. You have only Two options, both requier a "Loader Card" (of sorts)...

a) You can use CAS Studio 8.4 and load up a Fun7, Goldwafer or Dragon Loader Card from the Smartcard Setion, and then use a Cardburnner (i.e the CAS3), and then run the update from your STB.

b) You can start CAS Studio 8.4 go to the CAM Section choose the Dragon/T-Rex/Giga option that best matches your CAM, insert said CAM into your CAS3, and hope that you still have your Dummy Card and Ribbon Cable, cause the Dummy Card will relace the Loader Card.

AFAIK you can NOT update and or Upgrade a Dragon et.al any other way, and no updateing a Dragon CAM though CAS3 and a Dummy Card is not going to be any faster then with a Loader Card and your STB...

[Momba0]

Thanks, will give it a try.

[spacedvb]

Where i can get how to upgrade my T-rex module using Cas3 with a dummy card, any tutorial..

thanks