What do I need to update my M2 Card?

[Doda37]

no not working...is it possible that the card is wrong or
defectively? how can i test this??

Yes, but try another com port (another computer), do you see ATR card?

[sms13]

yes the atr i can see...i have only one com port but this works before always..i can program with this and cas3 programmer, gamma card, an*cond*, c*r*bro, titanium and wildcard without any problems...

[sms13]

yes works good to program M2+card with cas3 and phoenix led
i have programed and works very fast on dreambox with gbox
in ccam must have internal reader to set as on 357mhz

please can you make 2 screenshots and show these here? 1 if it show the message "os updated" and 1 if it show the message "card succesfull program"


i want to see which message i have to become, if it works. thanks in advance

[sms13]

With Cas 3 you must prog. M2 + card,conect your programmer with serial and usb cable, you start phoenix mode, program like picture your post,click hide and start loader for M2+, version 1.3, must work

please can you make 2 screenshots and show these here? 1 if it show the message "os updated" and 1 if it show the message "card succesfull program"


i want to see which message i have to become, if it works. thanks in advance

[sms13]

i use CASR in phoenix mode on 358Mhz

then i start m2p.exe

i click first on "open" then on "connect"
then i clock on "reset file" and wait until i get message OS updated.

then i load the file by clicking on download application.

when i get message, its doen, the card is done.

regards

keydemberµ

please can you make 2 screenshots and show these here? 1 if it show the message "os updated" and 1 if it show the message "card succesfull program"


i want to see which message i have to become, if it works. thanks in advance

[sms13]

iv had the same problem, i just increased the latency and tied again, untill it worked.

iv also heard of people's card suddenly died.

please can you make 2 screenshots and show these here? 1 if it show the message "os updated" and 1 if it show the message "card succesfull program"


i want to see which message i have to become, if it works. thanks in advance

[sms13]

Phoenix programmer (set at 3.57 MHz and Phoenix) like the old cards (mm2 )

please can you make 2 screenshots and show these here? 1 if it show the message "os updated" and 1 if it show the message "card succesfull program"


i want to see which message i have to become, if it works. thanks in advance

[Doda37]

Post yours picture, that We can see whats happened

[sms13]

so just please your pictures...

[Doda37]

first start duolabs,start phoenix, start loader ver. 1.3, conect...reset OS, and download application