Diablo Updated Infos - *** bin

[EMPB]

Fausto Emulator & BISS:
Cam settings to use: EMULATOR=OFF AUTO PMT=OFF FIXED CW=OFF DEBUG=ON
How to proceed:
1.Select Emulator function
2.Load ***s.bin
3.Press Connect Button
4.On your receiver select BISS Chanel wanted (example Disney ME 10°E)
5.Press on tabsheet BISS & Select same chanel (example Disney ME 10°E)
6.Select Cam IP (Cam ip list extracted during emulator connection)
7.Press Button "Send *** To Cam"
Now channel is decrypted!


Fausto Emulator & Seca2:
Ident 00006A worked chanels: Mezzo, ITélé, Trace TV, Motors TV & Sailing Channel (on Astra)
Table S2_NL.BIN must be deleted on cam
There is no conflicts between Fausto S2 Table & original card


Fausto Emulator & Seca1:
Worked only under FE -> AUTO PMT option must be ON


FAQ:
1.Possible to use original card with Fausto Emulator running: YES
2.Possible to use several cams with Fausto Emulator: YES (tested with 2 Cams connected & 2 original card on base)
3.I must disconnect Fausto Emulator for updating ***s: NO
Just move emulator windows-Add new *** on XML file-Save file-Select Fausto Emulator again-Reload fresh ***s.bin
New *** will be used with next ecms incoming without any disconnection.
4.Possible to do decode BISS chanels: YES (no problem with duplicate ident)
5.Possible to get SECA1 chanel decoded: YES (only with FE, not with cam emulator, AUTO PMT must be set to ON)
6.Possible to use DCW ***s under Nagra1, Nagra2 & cryptoworks: YES (only with FE, not with cam emulator DCW *** not
work & not appear in ***s list)
7.Possible decode MCM Belgique at 5°W: YES (only with FE, not with cam emulator)
8.Correct ***s inserted on ***s.bin but chanel not decrypted: Turn auto PMT=ON or update CAIDS.XML on cam then reboot cam

4.On your receiver select BISS Chanel wanted (example Disney ME 10°E)
5.Press on tabsheet BISS & Select same chanel (example Disney ME 10°E)
- Biss 10°E Disney ME is bad example as this is down (has been for months) is it not?

7.Possible decode MCM Belgique at 5°W: YES (only with Fausto Emulator, not with cam Emulator)
- In fact MCM Belgique does work with CAM emulator, has done for the last few UnderWorld releases.

DCW fixed under Underworld CAM emulator also.....Cryptoworks works, fairly sure Nagra1 & Nagra2 work too.

Please update info (ie test yourself!) rather than just cutting and pasting it.

[EMPB]

Today I have asked Saoud007 to update this info