Xcam angel firmware update to pmcia version

[cpaul2ss]

Hi I am a newbie on this subject.
I have a X-Cam with a Angel chip on it, the programmer is an Infinity Usb Phoenix compatible. I can program the X cam with two fun 6 cards. Since I have also a laptop I was wondering wether it is possible to Upgrade the X cam (firmware 1.061) to a P version so I can update it in future by laptop. Is there anyone who knows that this is possible by fun card, I have seen a manual with the 1078p firmware but this is done by programming the x cam directly from the pc.

Thanks CP

[satclaudio]

I have done with CAS2+ADDON
CIAO