Target not connect or target is error status!

**kaki1234** · 19-10-2008, 15:36:01

every time i want to flash my starsat 6300cu super i've got this message i have rs32 cable i use alimupg52 force loader

**Antonio Montene** · 19-10-2008, 15:45:12

Hello,
use this loader : http://www.satsupreme.com/attachment...2&d=1222291354 : aliminiupg5.2 - The message is because you are boot 3.08 and not 3.07
GOOD LUCK

**kaki1234** · 19-10-2008, 17:42:31

thanks for your help montene i will try it

**kaki1234** · 23-10-2008, 19:19:21

don't work montene don't know what to do? bad luck.

**i-mane2006** · 02-11-2008, 15:56:36

Hello . I have the same problem with two ( 02 ) Pc , but i flashed my starsat 6300 cu super with another pc , that means that the stb , cable and flash are good . the problem is in the Pc .
The first solution is to reinstall Win XP . If no , that means that the problem is hard ( in the mother board ) .

**Copycat** · 07-11-2008, 01:08:21

I get the same message with these loaders having a starsat sr-3500cuci ultra. rs232 cable is ok because i can load firmware.

Although i have only com1 when setting the loader to com 3 i get the following message

Please power on your STB.
Open Serial Port..
Sync to serial port..
Get Client protocol version & chunk
Time out when read data!

Any help appreciated and thank you for your good work guys, (at least some people enjoy your work)

**trojanz** · 09-02-2009, 12:49:14

same problem with Echolink 888 super plus

Thread: Target not connect or target is error status!

Thread Tools