Gamma Card Nova Update - New

[papadak]

I confirm that the trick with the ORIGINAL .gam file (date 03-04-08) works perfectly. This is the only file that has opened the package for over 24 hours in the last days. Tested in 3 cards. Just load it and leave the card in the receiver for about 2-3 hours. Then extract it and insert it again.

Please, upload the file

[kyriakos01]

please, upload the file

Πάρτω!! και καλή επιτυχία

[besttt]

yes you can with sataid loader buy doesnt mater because play only 4 hours

[mxantho]

This is for people with the latest gm card. Those people who tried loading 3-4-08 file with no luck. So follow those steps and hopefully.. everything will be back to normal. I tried so many things the last days, but only this method worked.

1) Open EMK3.1.
2) Press "Reset" two times.
3) Eurotools ==> Clean Card
4) Load Gam == > 3-4-08
5) Send to Card (This will take long, maybe an hour)
6) Put the card in your receiver @ NvCinm1. Leave the card for 2 hours in reader.
7) Close the receiver. Remove card
8) Open receiver @ NvCinm1. Plug your card in.
9) change 1-2 channels. If you get picture then stop here. Everything is fine.
10) Remove your card from receiver.
11) Open Gamaloader1.1
12) Load file 17-11-08.
13) Program
14) Put the card in your receiver @ NvCinm1 and wait to AU.
15) Everything will probably go blank in 3-4 hours.
16) Close your receiver. Remove card
17) Open receiver, then insert your card and it will AU again.

Follow those steps! I don't know if all those steps are mandatory for success. This the way I managed to get it working, and It hasn't stopped working for 4 days.

Regards

P.S. Do this at your own RISK! Don't blame me if anything goes wrong.

[mxantho]

Ego exo valei to 1711 se kainourgia karta apeftheias kai doulevei mia xara (4 meres) se DM7020 me irdeto cam


Esei me tin diadikasia pou akolouthises vlepeis kai toys dio?

Oxi, mono to gr paketo.

[gatos814]

this is it but it's a modify(16-10)

[gvaf]

You people should stop writing in greek in this forum. There is a greek section for greek posts. Try writing in English.

A tip from me which will help users with dreambox.
I run my card with newcs + cccam in a phoenix. When the card locks, I reprogram it and it works again for some hours, then it fails and I have to start again (as most people are at this time). Card lasts for 12 hours max.
However, i've found that if I run card with newcs + mgcamd, with the option to only send EMM when the channel is not decoding (it's inside mg_cfg) , the card will last much more than a few hours (actually it is running for 3 days now without locking again). It seems that either some of the EMMs block the card or the number of EMMs block the card. Thus, if you minimize the EMMs sent to the card, it will last longer.

Try to block "GA" emm from newcs config and see.

[gvaf]

You people should stop writing in greek in this forum. There is a greek section for greek posts. Try writing in English.

A tip from me which will help users with dreambox.
I run my card with newcs + cccam in a phoenix. When the card locks, I reprogram it and it works again for some hours, then it fails and I have to start again (as most people are at this time). Card lasts for 12 hours max.
However, i've found that if I run card with newcs + mgcamd, with the option to only send EMM when the channel is not decoding (it's inside mg_cfg) , the card will last much more than a few hours (actually it is running for 3 days now without locking again). It seems that either some of the EMMs block the card or the number of EMMs block the card. Thus, if you minimize the EMMs sent to the card, it will last longer.

Try to block the "GA" emm from newcs config and see.

[fanis52]

re paidia ti lysh yparxei me tis gamma....kleinoyn meta apo 2 meres...yparxei kati dokimasmeno??

[walantiss]

Mono me to 03-04 doyleyei paidia alla xoris cy