Pioneer Chat

[cptsurcouf]

Try to read and save the eeprom then erase or fill with 0xFF.
Do you use Pioneero V4 or V5?

[Dams83style]

je arrive pas a faire marcher mediasat connect pour les aes auto merci de votre aide

[funkyclem]

salut
j ai suivi exactement la doc je narrive pas a le flasher
dl10 est bien inscrit sur le démo
une fois clic sur envoyer un message s affiche:"pas de réponse du décodeur sur ce port serie"
j ai bien regle le port// sur ecp
j utilie pionero v5
merci

[cptsurcouf]

Next time post in english please.

Use pioneero v4.0
http://www.satsupreme.com/showthread.php?t=4087

[funkyclem]

sorry and thanks

[funkyclem]

i ve a problem
when I flash the ts5 this message"the // port could not be opened"
I use pionero v4
in bios port// -> ECP

[cptsurcouf]

I find this for you: (write by Sa1...dor)
"Sometimes the problem is caused by an update received on some computers as part of the windows xp service pack 2
To solve the problem of the blocked access to the parallel port you can check the "Ignore the windows version" in Pionero's configuration (parallel port section) and then execute Pionero in "windows 95 compatibility mode" : Right click on Pionero.exe, then click on "properties", select the "Compatibility" tab, check "Execute this program in compatibility mode for" and select "windows 95". "

[funkyclem]

hello cptsurcouf
fantastic
the first phase is good
BUT "negotiation phase 2 timeout"
i don't understand??

[cptsurcouf]

First check in config decoder model and mainboard type
second try with another parallel cable
and here is a soft for diagnostic (not necessary to authorised internet access)
I join also my gwiopm.sys and trap.bin ,unpack in pioneero directory

[Insano]

Sorry for my very late response, i was not at home during the past weeks.

I solved my problem.
My problem was a resistor that usually are not present in the same decoder of the same family.

Comparing the mainboard of my decoder with another one i found that on my decoder there was a 5600 ohm resistor connected between pin 5 and 7 of IC7002 and Q7010 point (near the display connector).

Removing this resistor all goes ok.