Infinity usb to program gamma card Please Help!

[Vreston]

Hello.
I have an Infinity USB programmer.
Can I use it to program a gamma card?
How can I do it?
I am running the software 1.60 build 1529 release
firmware version 1.00
driver version 1.10 build 1190

In the program I don't see that it has a phoenix mode or a choice of mhz 3.579 or 6.

I used to use it to program a fun card a couple of years ago.

Please help me out as soon as possible

Thank you very much!

[kostas1]

Hello.
I have an Infinity USB programmer.
Can I use it to program a gamma card?
How can I do it?
I am running the software 1.60 build 1529 release
firmware version 1.00
driver version 1.10 build 1190

In the program I don't see that it has a phoenix mode or a choice of mhz 3.579 or 6.

I used to use it to program a fun card a couple of years ago.

Please help me out as soon as possible

Thank you very much!

I do not have this programmer, but I white that it goes.
This picture tries to find
(perhaps utilites) and dan experiment.
Only if U have a infinity phoenix or unlimited.

[Vreston]

Thanks for the answer.
It's just the simple infinity usb not the phoenix.
Can you suggest a programmer for the job. Not an expensive one and not one that will be useless in a few years.
And a good online shop to buy it from.
Thanks again!

[kostas1]

Thanks for the answer.
It's just the simple infinity usb not the phoenix.
Can you suggest a programmer for the job. Not an expensive one and not one that will be useless in a few years.
And a good online shop to buy it from.
Thanks again!

..Hi.For me the best one is the CAS_3+