--------------------------- INSTALL THE DICEqC 1.2 MOTORIZED H-H MOUNT--------------------

-----------------------------------------------Page 1-----------------------------------------

1-1) Find an appropriate for installation first.

1-2) Make sure there is no obstacle in the sout sky such as tree or toll biilding.

1-3) Make sure the mounting pole is exactly leveld in vertical.

1-4) Fix the h-h motor on the mounting pole and attach the antenna dish on to the motor pole.

1-5) Make sure the center of the antenna dish is with the center of the motor well.

1-6) Make motor elevation at 52*.

1-7) make antenna dish scale 38* aproximately.

1-8) Tide all bolds and nuts. (not very tide)

1-9) Make koaxial RG6 cable connection . (see manual book)

1-10) Draw the koaxial RG6 cable as close as possible to the mounting pole to prevent from any
interference between antenna dish bracket and koaxial cable.

1-11) Rotate the motor all together with the antenna dish tru south by hand.

---------------------------------------------------o-------------------------------------------

MAKE SETTINGS

-------------------------------------------------pAGE 2----------------------------------------

2-1) Switch on your digital box receiver.
2-2) Put on hotbird 13*E channel. (RAI1,2,3)

Note: Thes is HUMAX settings other receivers are similar, manual settings apply for all.

2-3) (1) press menu (2) installation (3) service searching (4) antenna settings
(5) antenna alternative (6) antenna alternative (7) make DISEqC command mode user.

2-4) press west button for four times(4 seconds in between)
press exit end ok to store changed settings press menu to exit .

2-5) (1) press menu (2) installation (3) status (4) signal quality.

2-6) By hand rotate the motor all together with antenna dish to find the signal from west to east
slowly slowly and get the bast signal quality.

2-7) Tide the motor braket very well.

2-8) Now tilt the antenna dish up and down and get the highest signal quality.

2-9) Tide the antenna dish braket very well.

2-10) Now motor is all raddy set

---------------------------------------------------o----------------------------------------------

SETTINGS WITH OTHER SAT

-------------------------------------------------Page 3--------------------------------------------

3-1) put on astra 19.2*E channel taquilla or other.

3-2) (1) Press menu (2) installation (3) service searching (4) antenna settings
(5) antenna alternative (6) antenna alternative (7) make DISEqC command mode installer.

3-3) On movement press east or west by pressing left or right from your remote.

3-4) When you see the signal stop rotate immediately by press up or down left or right.

3-5) Chang DISEqC command from installer to user, puls back slowly slowly
until get the best signal press exit and ok to stor changes.

----------------------------------------------------o-----------------------------------------------
3-6) To set another sat all you have to do is the same like page 3 the different is the sat
for example eutelsat w2 16*E.
----------------------------------------------------o-----------------------------------------------

NOTE: YOU CAN ALMOST DRIVE THE MOTOR EAST/WEST VIA MANUAL BUTON ON THE BOTTOM OF THE MOTOR
(SEE MANUAL BOOK)