Need help: Gamma Card + SmartBee programmer

[Confidence]

hi guys,

i am totally new to gammacard programming
i bought gamma card with smartbee programmer 3,579 Mhz

then i bought an adapter to connect its com port over USB, because i have no COM interface on my computer

i opened gamma loader 2.5

tried clean card...it says "clean card" but nothing is moving or changing, and stays for 10 minutes....it does not change

i tried program card....same issue

when and how do i know if a card is succesfuly cleaned or programmed?

regards

[ali_alpha]

just folow by load file than prog card!!
or just use any loader to clean card than use the soft called emk-3.5 to programme your card
1-open the soft by cliking on
2-reste( if your card is cleaned you will see GAMMA ATR in atr section)
3-load *.gam
4-send to card - most see somme data sent to card)
5- when you see that data stop sent to card that mean your card finsh programed)
6-click rest secound time you most see that the atr is changed and the coco section is peopled!!)
7-click close to close the soft (do not unplug card untel you close the soft!! for your card safe)
8-use your card as you need.......!!!!

[miazoilaika]

ΕΥΧΑΡΙΣΤΩ ΠΟΛΥ