X marusha - About 6400

[PHILI]

HY Phili

I have some trouble to update my Receiver with new Keys ,i have a new softcam.key and use Cas link 1.16 b4 i open the file an see the right Keys ,than i patch it to Data bin,ok.

Next step is i Load the new patch file with key logo in the Box, but nothing ,its the old Keys in the Box and not the new.

Why this ,can you help me.

Thanks to you.

Hi, try this procedure:

1) Load in the Keylog PatchData.bin via the Browse button;
2) Set the com port to which you are connected to the decoder;
3) Upgrade set Type "keydata";
4) Finally, click on Next ... let the tool do all ... then click Next to writing data in flash and Finished at last to exit the program.

The decoder after some restarts on its own.

Go to Menu / System Setup / System TV press "0000" or "9999" on remote control if do not have the red dot in the lower right of the screen.

Bye

[marusha]

Which tool ??

Did you take for this procedure ,i have use 3,4 different tools and the same problem.

Is it maybe the Firm of the Digiquest that makes me Probs,i have the latest Digiquest of this Post.

Thanks so much phili for your Time and support to help .

Bye.

One question , did you speak German,then i send you a message hir in this Bord.

[PHILI]

Hi,

Which tool ??

This tool: http://www.satsupreme.com/showpost.p...3&postcount=21

Is it maybe the Firm of the Digiquest that makes me Probs,i have the latest Digiquest of this Post.

Firmware Digiquest or Tyran Fixed?

Try this Patchdata.bin dated 5-3-2009

Bye.

[marusha]

ok thank you Phili

i will taste an Report.

Thank so much.