Gamma Card show ffff caid

[bassjunkies]

I have a gamma card and when I run it on newcs it shows a ffff caid. I have tried everything. I programmed it with all the well known loaders and it seems that everything is ok. "Card successfully programed" ...etc. I even tried the HSN change method that is posted in this forum but still nothing. The card shown as an unknown ffff caid. Enen though in an original ****** cam it says the same thing ... "ffff caid unknown card - please insert original card". The card has a good gamma OS v1.4 atr but i can't do nothing. It seems that I cannot program it. Do you have any idea what happens??? Is my card dead???

[tasosgr]

try this http://www.satsupreme.com/showthread.php?t=44245
and test yor card first....id prog.

[bassjunkies]

I just tested my card with IDProg and this is the result.

RESET Hardware found: Phoenix

Convention = Direct convention
ATR Length = 20
ATR Data = 3B 9F 21 0E 47 41 4D 4D 41 43 41 52 44 20 56 20 31 2E 34 9D

T0 = 9F
T1 = 21
T2 = N/A
T3 = N/A
T4 = 41

History Len = 15
History Data = 41 4D 4D 41 43 41 52 44 20 56 20 31 2E 34 9D
F = 33 : Assumes baud rate of 9600 bps
D = 01 : No adjustment to the ETU
P = 14 : bytes Guard Time


What I have to do after?

[tasosgr]

ok your card is emmty so load file with gam.loader 1.0 or 1.1 and you are ok

3b 9f 21 0e 49 52 44 45 54 4f 20 41 43 53 20 56 34 2e 31 9d ..ok=WITH FILE


CLEAN CARD ATR: 3B 9F 21 0E 47 41 4D 4D 41 43 41 52 44 20 56 20 31 2E 34 9D =emmty card,but is ok redy to load gam .file

[bassjunkies]

when I load it with a gam file the card still remains empty. It seems that the card don't hold the data. I don't know what happens!!! The gamma loader 1.0 or 1.1 says that the card successfully programed.

[vamas]

what programmer asre you using?

[tasosgr]

I see the same film some cards ATR OK but not accept file ...problem card

[bassjunkies]

I use the dynamite plus programmer. I have tried everything. Phoenix mode 6mhz, 3.58 etv. I have another card and when i programm it with the same programer on phoenix mode 6mhz everything is OK. But the second card it seems that is not accepting any file. Why is that ? How I can fix it?

[tasosgr]

i use the dynamite plus programmer. I have tried everything. Phoenix mode 6mhz, 3.58 etv. I have another card and when i programm it with the same programer on phoenix mode 6mhz everything is ok. But the second card it seems that is not accepting any file. Why is that ? How i can fix it?

problem card....you canot fix sorry

[bassjunkies]

anyway!!! Thank you very much for you valuable informations.