HDVB2 : CCCAM and GBOX For Echolink and colones

[sami.sami]

HDVB2 : CCCAM and GBOX For Echolink and colones

* click inicio
-you make Sure that is ok

23221260.png

* put your cccam server here

87759372.png

* server is ok

39200258.png

* give cccw keys

37733566.png


After tested it is better than flycccam

In Your Echolink actived gbox sssp : Menu
system setup
serial port use : gbox sssp

[sami.sami]

open file
clic in cccm

26144331.jpg

put your ccam server here

86127896.jpg

to actived cccam click : Active cccm

26196482.jpg


66889226.jpg

[sami.sami]

23.12.2009

v1.1.5

[kammy]

Thannk you sami for exchange

[sami.sami]

08.01.2010

HDVB v1.1.6

[Fiuhost]

Hello

Thanks for this software

I have a problem, I connected to server, ecm send and I receive CW but still on TV is encrypt program, receiver is FTE S 202 on mode sssp-gbox,sw is connected with receiver because when I change program on receiver, sofware change it on monitor screen of software. I am working with ccam protocol.

Can you please put some tutorials and is that sw working with N+D+S and I+r+d+e+t+o programms.

[Fiuhost]

After 2 days of testing (changing many firmware of my receiver) confirm that it is working very good except with n.d.s. programmes. It freeze 1-2 seconds of every changes of CW key.

[zvonko67]

kolega,evo skinuo sam ga i stavljam na naš upload,a ti budi dobar i ljudima objasni u kratkim crtama aktiviranje programa i kaj sve otvara! poz

[sbsebmat]

Good job guys!
I tried to set this for my FTE AliB, but I cannot get the server name to appear in the window in HDVB. I can see the ECM changing in the monitor window, but nothing under the CCCam window. Help please.
I did put a cline in the file cccam.cfg like this: server1=servername:port:user:pass
I'm almost there but I need a little help here!

Thank you

[aime_jeux]

salut
HDVB v1.1.7